1/4" Mini Inline Lubricator for Air Compressor Tools Oiler Oil Lubrication L2000

1/4" Mini Inline Lubricator for Air Compressor Tools Oiler Oil Lubrication L20001 4" Mini Inline Lubricator for Air Compressor Tools Brand new inline oiler for compressed air tools. This oil lubricator has 1 4" female NPT threads on the inlet side and 1 4" female NPT threads on the outlet side. Using this lubricator improves the performance of your air tools and helps extend the life of your tools. This is a great and inexpensive way to make sure that your air tools are properly lubricated. This is a great quality oiler and

• 3450 RPM

This is a good quality belt that measures 50" outside diameter and is 9/16" wide

If more than one outlet is needed it is common to use a "tee" to make multiple ports which can be purchase at a local hardware store

This valve also has a muffler in the exhaust air port to quiet down the unloaded exhaust air that is released once the compressor reaches 125 PSI

The switch is set to turn on at 95 PSI and turn off at 125 PSI

two 1/4" FNPT connections and measures about 1-1/2" in length which is commonly used to split one regulator output or air hose line into two

This is a 2 horsepower pump that will deliver up to 5

• 115/230 Volts

If they look the same and the engine HP is less than 9 HP then it should mount right up

This unique design give you the ability to mount a 184T frame motor to any flat surface without a existing mounting surface or if the surface has mounting slots for a different frame size you can adapt the 184T frame with this mount

• Kwik Grip Safety Chuck

This belt measures 1/2" wide x 66" long outside diameter